Caravan AWD V6-201 3.3L (1991)
Fig. 7 Driveshaft components
7.
Slide small end of boot over shaft, then place clamp over groove on boot.
Fig. 27 Installing circlip. Outer CV joint
8.
Insert new circlip in shaft groove. Do not over expand or twist circlip during assembly. On S.S.G. unit has a reusable circlip retainer that is part of
driver assembly.
9.
Position joint housing on shaft, then engage by tapping sharply with a soft faced mallet.
10.
Ensure snap ring is properly seated by attempting to pull joint from shaft.
11.
Position boot over boot groove in housing, then install clamp.
Disassembly
Driveshaft assembly should be identified before starting service procedure. Refer to SYSTEM I.D..