Caravan AWD V6-201 3.3L (1991)
Fig. 7 Driveshaft components
1.
Remove boot clamps, then pull back boot to gain access to joint.
2.
Clean grease from joint.
Fig. 16 Removing outer CV joint from shaft
3.
On all models except S.S.G. units, place driveshaft assembly in suitable vise and support outer joint. Remove outer joint from shaft by tapping
top of joint body with a soft hammer.
4.
Remove circlip from shaft groove and discard.
Fig. 17 Circlip retainer in cross. S.S.G. units
5.
On S.S.G. units, loosen damper weight bolts, slide it and boot towards inner joint. Remove circlip, then joint from shaft.
6.
On all units, if constant velocity joint is operating satisfactorily and grease does not appear contaminated, refer to ASSEMBLY.
7.
If constant velocity joint is noisy or badly worn, replace entire unit. The repair kit will include boot, clamps, circlip and lubricant. Clean and
inspect joint outlined in the following steps.
