Challenger SRT-8 V8-6.1L (2009)
Oil Spray Jet: Service and Repair
Piston Oil Cooler Jet - Installation
INSTALLATION
1. Install the Piston Oil Cooler Jet. (1)
2. Tighten the bolt to 13 Nm (115 lbs. in.) (2)
NOTE: Mopar(R) Engine RTV must be applied to the 4 T-joints, (area where front cover, rear retainer, block, and oil pan gasket meet). The
bead of RTV should cover the bottom of the gasket. This area is approximately 4.5 mm x 25 mm in each of the 4 T-joint locations.
3. Clean the oil pan mating surfaces of the engine block and oil pan.
4. Apply Mopar(R) Engine RTV at the 4 T- joints. (1,2)
5. Install a new oil pan gasket/windage tray assembly.