Charger V6-3.5L (2009)
NOTE: If installing a lower control arm engine cradle bolt that is a wheel alignment adjustment bolt (1) (identifying lengthwise grooved shaft
(2)), make sure to install it in the same position which it was in upon removal. For more details on installation of this special bolt, See:
Alignment/Service and Repair .
1. Slide lower control arm (1) into position in engine cradle (2) and place ball joint stem into mounting hole in knuckle.
NOTE: When installing lower control arm engine cradle bolts, it important to note that the forward bolt is installed front-to-rear and the
rearward bolt is installed rear-to-front.
2. Install lower control arm mounting bolts and nuts (3 and 4). Do not tighten bolts at this time.
3. Raise steering gear to mounted position and install lower mounting bolts (2 and 3). Install upper mounting bolt (4) and nut. Tighten all mounting
bolts to 122 Nm (90 ft. lbs.).