Charger V6-3.5L (2009)
4. Install heat shields (3) above both inner tie rod bellows (2). Tighten mounting screws to 7 Nm (62 in. lbs.).
5. Pull downward on control arm and guide ball joint stud into knuckle (3). Install NEW nut (4) on ball joint stud. Tighten nut by holding ball joint
stud with a hex wrench while turning nut with a wrench. Tighten nut using crow foot wrench on torque wrench to 68 Nm + 90° turn (50 ft. lbs. +
90° turn).
6. Align shock clevis bracket (2) with lower control arm (7) bushing and install mounting bolt (1) and nut (3). Do not tighten nut at this time.