Charger V8-5.7L (2008)
Underhood Lamp: Service and Repair
Underhood Lamp Unit - Police
Removal
REMOVAL
1. Open hood, disconnect and isolate the battery negative remote terminal or pull fuse in the PDC.
2. Disconnect the wire harness connector (1) from lamp unit (2).
3. Remove the push-pin fastener attaching underhood lamp unit (2) to inner hood panel.
4. Remove the underhood lamp unit (2) from the vehicle.
Installation
INSTALLATION
1. Position the underhood lamp unit (2) on the hood inner panel.
2. Install the push-pin fastener attaching the lamp unit base (2) to the inner hood panel.
3. Connect the wire harness connector (1).
4. Connect the battery negative remote cable or reinsert fuse in the PDC.
5. Close hood.