Charger SRT-8 V8-6.1L (2009)
5. (if equipped) Turn foot rest over and disconnect the DTCM connector (1) from the DTCM (2).
6. Remove the foot rest (3) from the vehicle.
Front Floor Foot Rest - Installation
INSTALLATION
1. (if equipped) Connect the electrical connector (1) to the DTCM (2).
2. Pull the outboard edge of the driver side front floor carpet up and away from the floor far enough to position the foot rest (1) between the front
floor panel and the carpet.
3. Engage the tab (3) at the top of the foot rest into the slot (4) in the dash panel.
4. Position the hole at the base of the foot rest over the weld stud (5) on the front floor panel.