Charger SRT-8 V8-6.1L (2009)
Oil Temperature Sensor/Switch: Service and Repair
Oil Temperature Sensor - Installation
INSTALLATION
NOTE: Apply Mopar(R) Thread Sealant with PTFE to the sensor threads before installing into the engine block.
1. Install the oil temperature sensor (1).
2. Connect the oil temperature sensor electrical connector (1).
3. Position the generator and install the upper mounting bolt finger tight.
4. Raise and support the vehicle.
5. Install the generator lower mounting bolts (1) and tighten to 55 Nm (41 ft. lbs.).
