Charger SRT-8 V8-6.1L (2009)
1. Install water pump and mounting bolts (2). Tighten mounting bolts to 28 Nm (20 ft. lbs.).
2. Make sure double ended bolt (3) is in the proper location. Tighten double ended bolt to 28 Nm (20 ft. lbs.).
3. Install thermostat See: Cooling System/Thermostat/Service and Repair/Engine Coolant Thermostat - Installation.
4. Install accessory drive belt See: Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair/Removal and
Replacement/Serpentine Accessory Drive Belt - Installation.
5. Install the radiator fan assembly See: Cooling System/Radiator Cooling Fan/Service and Repair/Cooling Fan - Installation.
6. Connect negative battery cable.
7. Evacuate air and fill cooling system.See: Procedures/Water Pump - Coolant Air Evacuation
8. Check cooling system for leaks.See: Cooling System/Testing and Inspection
