Charger SRT-8 V8-6.1L (2009)
1. Position the fresh air inlet housing (3), particulate air filter (1) and filter housing (4) as an assembly onto the engine compartment side of the dash
panel (2).
2. Install the two nuts (5) that secure the fresh air inlet housing and filter housing to the dash panel. Tighten the nuts to 7 Nm (62 in. lbs.).
3. Position the insulator (4) into its installed location and install the push-pin retainer (5) that secures the insulator to the front of the fresh air inlet
housing (2).
4. Install the push-pin retainer (1) that secures the fresh air inlet housing to the right inner fender (6).
5. Reach under the fresh air inlet housing and install the wire harness retainer (3) into the bottom of the air inlet housing, if equipped.
6. Position the powertrain control module (PCM) or the engine control module (ECM) (2) (depending on engine application) into its installed
location.
7. Position the strut support (3) into the engine compartment and loosely install the two bolts (1) that secure the strut support and the ECM/PCM to
