Charger SRT-8 V8-6.1L (2009)
the passenger side strut tower (6).
8. On LHD models, install the purge solenoid (5) onto its mounting bracket located on the right strut tower.
9. Engage the retainer that secures the wire harness (4) to the bottom of the strut support.
10. Engage the wiper motor (5) to the bracket (4) located on the strut support (2).
11. Position the strut support to the driver side strut tower and loosely install the two bolts (1) that secure the support to the tower.
12. Tighten all four bolts that secure the strut support to 38 Nm (28 ft. lbs.).
13. Install the cowl top panel onto the dash panel See: Body and Frame/Cowl/Cowl Moulding / Trim/Service and Repair/Cowl Panel Cover -
Installation.
14. Reconnect the negative battery cable.
HVAC Housing - Removal
HOUSING-HVAC ASSEMBLY
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation See: Service
Precautions/Warning and See: Service Precautions/Caution . Failure to follow the warnings and cautions could result in possible
personal injury or death.
WARNING: On vehicles equipped with airbags, disable the airbag system before attempting any steering wheel, steering column, or instrument
panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the
airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag
system. Failure to take the proper precautions could result in accidental airbag deployment and possible personal injury or death.
NOTE: The HVAC housing must be removed from the vehicle and disassembled for service of the A/C evaporator.
NOTE: LHD model shown in illustrations. RHD model similar.
1. Recover the refrigerant from the refrigerant system See: Service and Repair/Refrigerant System Recovery.
