Charger SRT-8 V8-6.1L (2009)
5. Tighten the clamp screw (1) at the base of the spot lamp head assembly in small increments while testing the effort required to rotate the spot lamp
between the stowed and operating positions. Stop tightening the clamp screw when the spot lamp can maintain any desired position.
6. Position the A-pillar trim to the spot lamp outer tube.
CAUTION: Support the head of the spot lamp while tightening the head assembly clamp screw. Maintain an operating or vertical position.
7. Install the handle to the outer tube.
a. Position the spot lamp handle in the operating (downward close to vertical) position to the outer tube.
b. There are two detent positions to which the handle must line up and engage. Rotate the knob of the handle and the handle base to aid in
engaging each of the detents. Using the wedge nut opening on the handle for visual aid, rotate the handle as necessary while installing, in order
to bring the flat detent on the intermediate shaft into view along the bottom of the opening.
8. Tighten the bolt (1) retaining the handle to the outer tub and tighten to 6.5 Nm (58 in. lbs.).
