Charger SRT-8 V8-6.1L (2009)
Spot Lamp: Service and Repair
Spot Lamp - Installation
LAMP
CAUTION: Make sure that the master spot lamp feed or either the left or right spot lamp feed are removed from the Power Distribution
Center (PDC) before performing service on the spot lamps.
1. Install the spot lamp outer tube and mounting bracket to the A-pillar.
2. Install the screws retaining the spot lamp mounting bracket to the A-pillar and tighten to 33 Nm (29 in. lbs.).
3. Carefully lift the edge of the secondary door seal along the windshield pillar to expose the spot lamp outer tube and apply a small amount of clear
silicone sealer to the base of the outer tube.
4. Carefully install the spot lamp head with the intermediate and inner shafts to the outer tube and mounting bracket until the head assembly bottoms
out on the outer tube.
