Charger SRT-8 V8-6.1L (2009)
Seals and Gaskets: Service and Repair
Output Shaft Seal - Removal
REMOVAL
1. Remove the propeller shaft See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and Repair/Propeller Shaft - Removal.
Move propeller shaft to the right and tie up.
2. Verify that the transmission is in PARK in order to prepare for the removal of the output shaft nut.
NOTE: When removing the propeller shaft flange be certain the shim remains on the output shaft.
3. Remove the nut, with a 30 mm 12 point socket, holding the propeller shaft flange to the output shaft and remove the flange.
4. Remove the output shaft seal with suitable screw and slide hammer.
