Charger SRT-8 V8-6.1L (2009)
Seals and Gaskets: Service and Repair
Output Shaft Seal - Installation
INSTALLATION
1. Position the new output shaft seal over the output shaft and against the transmission case.
2. Use Seal Installer 8902A (1) to install the seal.
3. Verify that the transmission is in PARK in order to prepare for the installation of the output shaft nut.
NOTE: When installing the propeller shaft flange be certain the shim remained on the output shaft.
4. Install the propeller shaft flange onto the output shaft and install an new flange nut. Tighten the flange nut, with a 30 mm 12 point socket, to 200
Nm (147.5 ft.lbs.).
5. Stake the output shaft nut to the output shaft as follows.Place the Staking Tool 9078 (2) and Driver Handle C-4171 onto the output shaft.
6. Rotate the Staking Tool 9078 (2) until the alignment pin (3) engages the output shaft notch (4).
