Colt L4-1597cc 1.6L DOHC (1989)
INSPECTION:
-
Check the hub for cracks and spline for wear.
-
Check the oil seal for damage.
-
Check the knuckle for cracks.
-
Check for defective bearing.
-
NOTE: If the meshing of the wheel bearing outer race and the knuckle, or of the wheel bearing inner race and the hub, is loose, replace
the bearing.
SERVICE POINTS OF INSTALLATION
3. Installation of washer / 2. Drive shaft nut / 1. Cotter pin
1. Be sure to install the washer and drive shaft nut in the specified direction.
2. After installing the wheel, lower the vehicle to the ground and finally tighten the drive shaft nut.
3. If the position of the cotter pin holes does not match, tighten the nut up to 260 Nm (188 ft.lbs) in maximum.
4. Install the cotter pin in the first matching holes and bend it securely.
