Dakota 4WD V6-3.7L (2008)
3. Make sure oil pan (1) and case rail are clean and dry. Install an 1/8" bead of RTV to the transmission oil pan and install to case. Tighten bolts (2)
to 20 Nm (14.5 ft. lbs.).
4. Lower vehicle and connect the transmission range sensor (5) connector.
5. Connect solenoid/pressure switch assembly connector.
6. Connect the variable line pressure connector (4), if equipped.
7. Lower vehicle.
8. Fill transmission with ATF+4, Automatic Transmission Fluid. Verify proper fluid level. See: Service and Repair/Procedures/Transmission Fill -
42RLE
NOTE: If the valve body has been reconditioned or replaced, it is necessary to perform the Quick Learn Procedure. See: Control
Module/Service and Repair/TCM Quick Learn
