Dakota 4WD V6-3.7L (2008)
Valve Body: Overhaul
Disassembly
DISASSEMBLY
NOTE: If the valve body is being reconditioned or replaced, it is necessary to perform the Quick Learn Procedure using the scan tool See:
Control Module/Service and Repair/TCM Quick Learn
1. Remove the electrical connectors from the pressure control solenoid (1) and the line pressure sensor (2).
2. Remove the screws (6) holding the pressure control solenoid (1) and line pressure sensor (2) to the valve body.
3. Remove the pressure control solenoid and line pressure sensor from the valve body.
4. Remove the shoulder screw (3) holding the variable line pressure header (4) to the valve body.
5. Remove the variable line pressure header from the manual shaft (5).
6. Remove manual shaft seal.
7. Remove manual shaft screw (1).