Dakota 4WD V8-4.7L VIN J (2007)
Gear Sensor/Switch: Description and Operation
NV243 Transfer Case
Description
DESCRIPTION
The transfer case mode sensor (1) is an electronic device whose output can be interpreted to indicate the shift motor shaft's rotary position. The sensor
consists of a magnetic ring and four Hall Effect Transistors to create a 4 channel digital device (non-contacting) whose output converts the motor shaft
position into a coded signal. The TCCM must supply 5VDC (+/- 0.5v) to the sensor and monitor the shift motor position. The four channels are denoted
A, B, C, and D. The sensor is mechanically linked to the shaft of the cam which causes the transfer case shifting. The mode sensor draws less than 53
mA.
Operation
OPERATION
During normal vehicle operation, the Transfer Case Control Module (TCCM) monitors the mode sensor outputs at least every 250 (+/-50) milliseconds
when the shift motor is stationary and 400 microseconds when the shift motor is active. A mode sensor signal between 3.8 Volts and 0.8 Volts is
considered to be undefined.
Refer to SECTOR ANGLES vs.TRANSFER CASE POSITION for the relative angles of the transfer case shift sector versus the interpreted transfer case
gear operating mode. Refer to MODE SENSOR CHANNEL STATES for the sensor codes returned to the TCCM for each transfer case mode sensor
position. The various between gears positions can also be referred as the transfer case's coarse position. These coarse positions come into play during
shift attempts.
Sector Angles Verses Transfer Case Position
