Daytona IROC R/T L4-135 2213cc 2.2L DOHC Turbo VIN A FI (1993)
Throttle Body: Service and Repair
Air Cleaner And Throttle Body Assemblies
Air Cleaner And Throttle Body Assembly
REMOVAL
1.
Fuel system pressure release must be performed prior to service. See: Fuel Filter/Fuel Pressure Release/Service and Repair
2.
Disconnect negative battery cable, and remove air cleaner.
3.
Remove the turbocharger to throttle body hose and its clamp.
4.
Disconnect the following electrical connectors:
^ Throttle Position Sensor (TPS)
^ Idle Air Control (IAC) motor
5.
Remove the throttle return spring.
6.
Remove throttle cable.
7.
Disconnect the vacuum hoses from the throttle body.
8.
If the vehicle is equipped with an automatic transmission and/or speed control, remove the kick-down and speed control cables.
9.
Remove throttle body mounting nuts and lift throttle body off of intake plenum.
10.
Discard old intake gasket.
INSTALLATION
1.
Clean the throttle body mounting surface on the intake plenum.