Durango 4WD V8-4.7L VIN P Flex Fuel (2007)
3. Lower the engine using special tool (1) #8534 until the through bolts rest onto the slots in the frame brackets.
4. Tighten the thru bolt nuts to 94 Nm (70 ft. lbs.).
5. Install the oil drain trough.
6. Install the engine oil filter.
7. Install the cooling fan.
8. Reconnect the negative battery cable.
4WD
NOTE: For mount to engine block and left engine bracket to front axle bolts, apply Mopar(R) Lock and Seal Adhesive, Medium Strength
Threadlocker.
1. Install the right and left side engine mount brackets (2) to the engine.
2. Install the right and left side engine mounts to the front axle. Torque nuts to 94 Nm (70 ft. lbs.).
3. Raise the front axle into the frame and install the left and right side thru bolts. Torque nuts to 94 Nm (70 ft. lbs.).
4. Insert the two upper thru bolts into the right and left side engine mounts and loose assemble the two nuts onto the thru bolts.
5. Lower the engine using special tool (1) #8534 until the left and right side engine brackets rest on the through bolts, and the lower engine bracket
through holes align with the engine mounts, and the left engine bracket holes align with the front axle slots.
6. Loose assemble the bolts that attach the front axle to the left engine bracket.
7. Loose assemble the lower thru bolts.
8. Torque the nuts for the thru bolts to 101 Nm (75 ft. lbs.).
9. Torque the bolts that attach the front axle to the left engine bracket to 101 Nm (75 ft. lbs.).
10. Install the oil drain trough.
11. Install the engine oil filter.
12. Install the cooling fan.
13. Reconnect the negative battery cable.
