Durango 4WD V8-4.7L VIN P Flex Fuel (2007)
REAR CONTROL PANEL
The rear A/C-heater control (1) is located at the rear of the center floor console (2) and allows intermediate seat passengers to adjust rear air distribution,
temperature and blower motor speed when the center control knob on the front A/C-heater control (3) is set to the Rear position.
Automatic Single Zone With Rear Heat And A/C
AUTOMATIC SINGLE ZONE WITH REAR HEAT AND A/C
The A/C-heater control (1) for the automatic temperature control (ATC) single zone front and rear heating-A/C system allows both the front and
intermediate seat passengers the ability to automatically or manually regulate air temperature as well as fan speed and provides floor outlets near the
right rear door and overhead outlets at each rear intermediate outboard seating position. Primary control for the rear blower motor is on the front
A/C-heater control. All controls are identified by ISO graphic symbols.
FRONT CONTROL PANEL
The front A/C-heater control and integral computer is located in the instrument panel and contains:
-
a push button Auto mode control (2).
-
a rocker switch control that selects comfort temperatures from 15° to 29° C (60° to 85° F) (3). Comfort temperatures are shown in the
vacuum-fluorescent (VF) digital display (4). If the set temperature is 15° C (60° F) and down (-) is pressed, the A/C-heater control will attempt to
achieve the lowest temperature possible, but the display will show LO. If the set temperature is 29° C (85° F) and up (+) is pressed, the A/C-heater
control will attempt to achieve the highest temperature possible, but the display will show HIGH. Temperatures can be displayed in either Metric
or Fahrenheit, which is selected from the overhead console.
-
a push button on/off control which allows the system to be completely turned off (5). The display is blank when the heater-A/C system is off,
except for the electric backlight (EBL) symbol, if EBL is on.
-
a push button A/C on/off control (6). An ISO Snowflake symbol appears in the display when the A/C system is in operation, whether under manual
or automatic control.
-
a push button air recirculation control (7). A ISO Recirculation symbol appears in the display when the button is pressed, or when the system
exceeds 80 percent circulated air under automatic control due to high A/C demand.
