Durango 4WD V8-4.7L VIN P Flex Fuel (2007)
Air Bag Control Module: Service and Repair
Removal
REMOVAL
WARNING: To avoid serious or fatal injury on vehicles equipped with side curtain airbags, disable the supplemental restraint system before
attempting any occupant restraint controller diagnosis or service. The occupant restraint controller contains a rollover sensor, which enables
the system to deploy the side curtains in the event of a vehicle rollover event. If an occupant restraint controller is accidentally rolled during
service while still connected to battery power, the side curtain airbags will deploy. Disconnect and isolate the battery negative (ground) cable,
then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable
the supplemental restraint system. Failure to take the proper precautions could result in accidental airbag deployment.
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect
and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further
diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result
in accidental airbag deployment.
WARNING: To avoid serious or fatal injury, never strike or drop the occupant restraint controller, as it can damage the impact sensor or
affect its calibration. The occupant restraint controller contains the impact sensor, which enables the system to deploy the supplemental
restraints. If an occupant restraint controller is accidentally dropped during service, the module must be scrapped and replaced with a new
unit. Failure to observe this warning could result in accidental, incomplete, or improper supplemental restraint deployment.
1. Disconnect and isolate the battery negative cable. Wait two minutes for the system capacitor to discharge before further service.
2. Remove the center console from the top of the floor panel transmission tunnel.
3. Disconnect the two body wire harness connectors (1) from the Occupant Restraint Controller (ORC) (2) connector receptacles located on the
forward facing side of the module. To disconnect the wire harness connectors from the ORC, depress the release tab and lift the lever arm on each
connector.
4. Remove the three screws (3) that secure the ORC to the ORC bracket (4) that is welded onto the top of the floor panel transmission tunnel.
5. Remove the ORC from the floor panel transmission tunnel.
