Durango 4WD V8-4.7L VIN P Flex Fuel (2007)
Air Bag Control Module: Service and Repair
Installation
INSTALLATION
WARNING: To avoid serious or fatal injury on vehicles equipped with side curtain airbags, disable the supplemental restraint system before
attempting any occupant restraint controller diagnosis or service. The occupant restraint controller contains a rollover sensor, which enables
the system to deploy the side curtains in the event of a vehicle rollover event. If an occupant restraint controller is accidentally rolled during
service while still connected to battery power, the side curtain airbags will deploy. Disconnect and isolate the battery negative (ground) cable,
then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable
the supplemental restraint system. Failure to take the proper precautions could result in accidental airbag deployment.
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect
and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further
diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result
in accidental airbag deployment.
WARNING: To avoid serious or fatal injury, never strike or drop the occupant restraint controller, as it can damage the impact sensor or
affect its calibration. The occupant restraint controller contains the impact sensor, which enables the system to deploy the supplemental
restraints. If an occupant restraint controller is accidentally dropped during service, the module must be scrapped and replaced with a new
unit. Failure to observe this warning could result in accidental, incomplete, or improper supplemental restraint deployment.
1. Carefully position the Occupant Restraint Controller (ORC) (2) to the ORC bracket (4) on the floor panel transmission tunnel. When the ORC is
correctly positioned, the arrow on the ORC label will be pointed forward in the vehicle and the locating pin on the bottom of the right ORC
mounting flange will be engaged into the locating hole in the ORC bracket.
2. Install and tighten the three screws (3) that secure the ORC to the ORC bracket that is welded onto the floor panel transmission tunnel. Tighten the
screws to 11 Nm (8 ft. lbs.).
CAUTION: The lever arms of the wire harness connectors for the ORC MUST be in the unlatched position before they are inserted into their
connector receptacles on the ORC or they may become damaged.
3. Reconnect the two body wire harness connectors (1) to the ORC connector receptacles located on the forward facing side of the module. Be
certain that the latches on both connectors are each fully engaged.
4. Reinstall the center console onto the top of the floor panel transmission tunnel.
5. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed
following service of any supplemental restraint system component.
