Durango 4WD V8-5.7L Hybrid (2009)
Vehicle Lifting: Service and Repair
HOISTING AND JACKING
WARNING: On vehicles equipped with the high voltage system, you must thoroughly read and follow all High Voltage Safety procedures. In
addition, before performing any diagnostic or service procedure near a high voltage component, you must perform the High
Voltage Power Down. Failure to follow these instructions may result in possible serious or fatal injury See: Hybrid Drive
Systems/Battery System, Hybrid Drive/Service Precautions
WARNING: The hoisting and jack lifting points provided are for a complete vehicle. When a chassis or drivetrain component is removed from
a vehicle, the center of gravity is altered making some hoisting conditions unstable. Properly support or secure vehicle to hoisting
device when these conditions exist.
FLOOR JACKING
Correct Vehicle Lifting Locations - Typical
CAUTION: Do not attempt to lift a vehicle with a floor jack positioned under:
-
an axle tube.
-
aluminum differential.
-
a body side sill.
-
a steering linkage component.
-
a drive shaft.
-
the engine or transmission oil pan.
-
the fuel tank.
-
a front suspension arm.
When properly positioned, a floor jack can be used to lift a Durango vehicle. Support the vehicle in the raised position with jack stands at the front and
rear ends of the frame rails.
HOISTING
A vehicle can be lifted with:
-
a single-post, frame contact hoist.
-
a twin-post, chassis hoist.
-
a ramp-type, drive on hoist.
NOTE: When a frame contact type hoist is used, verify that the lifting pads are positioned properly.