Durango 4WD V8-5.9L VIN Z (1998)
2.
Remove the driver side screw that attaches the striker bezel to the underside of the armrest cover (Figure 1).
3.
Insert the new screw from bumper kit p/n 05015588AA into the new stop bumper. Then. install the stop bumper screw assembly into the location
where the screw was removed in Step 2.
4.
Verify that the center armrest cover closes easily and that the rattle is gone. If the center armrest cover is difficult to close, the armrest cover can be
carefully bent up at the ends (in the direction of a smile) to adjust the tension between the stop bumper and the cover.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No:
23-14-21-91
0.2 Hrs.
FAILURE CODE: PS - New Part
