Durango 4WD V8-5.9L VIN Z (1998)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Front Antilock Valve Replacement
NOTE: If the antilock control assembly needs to be replaced, the rear axle type and tire revolutions per mile must be programed into the new Controller
Antilock Brake (CAB).
REMOVAL
1. Disconnect battery negative cable.
HCU Brake Lines
2. Remove the brake lines from Hydraulic Control Unit (HCU).
Harness Connector Locks
3. Push the harness connector locks to release the locks, then remove the connectors from the CAB.
