Durango 4WD V8-5.9L VIN Z (1998)
Sealant Application To Bearing Cap
6. Apply 5 mm (0.20 inch) drop of Loctite 518, or equivalent, on each side of the rear main bearing cap. DO NOT over apply sealant or allow the
sealant to contact the rubber seal. Assemble bearing cap to cylinder block immediately after sealant application.
7. To align the bearing cap, use cap slot, alignment dowel and cap bolts. DO NOT remove excess material after assembly. DO NOT strike rear cap
more than 2 times for proper engagement.
8. Clean and oil all cap bolts. Install all main bearing caps. Install all cap bolts and alternately tighten to 115 Nm (85 ft. lbs.) torque.
9. Install oil pump.
Apply Sealant To Bearing Cap To Block Joint
Apply Mopar Silicone Rubber Adhesive Sealant, or equivalent, at bearing cap to block joint to provide cap to block and oil pan sealing. Apply
enough sealant until a small amount is squeezed out. Withdraw nozzle and wipe excess sealant off the oil pan seal groove.
10. Install new front crankshaft oil seal.
11. Immediately install the oil pan.
