Durango 4WD V8-5.9L VIN Z (1998)
18.
Remove the steering column mounting nuts (Figure 7) and lower the steering column to the floor.
19.
Remove the screw from the center of the headlamp and dash to instrument panel bulkhead wire harness connectors and disconnect the connectors.
20.
Disconnect the two body wire harness connectors from the two instrument panel wire harness connectors that are secured to the outboard side of
the instrument panel bulkhead connectors.
21.
Disconnect the three wire harness connectors (one from the body wire harness and two from the headlamp and dash wire harness) from the three
junction block connector receptacles located closest to the dash panel.
22.
Disconnect the instrument panel wire harness connector form the stop lamp switch connector receptacle.
23.
Remove the park brake release rod from the pedal assembly (Figure 8).
24.
Pull the floor carpet back from the front of the floor panel transmission tunnel far enough to access the center support bracket mounting screws.
25.
Remove the two screws that secure the center support bracket to the instrument panel.
