Durango 4WD V8-5.9L VIN Z (1998)
12.
If the vehicle is equipped with a column shift automatic transmission, put the transmission range selector into Park. Then, remove the PRNDL
drive cable from the PRNDL lever (Figure 5). Push the tabs on top of the cable retainer, then squeeze the sides to remove the retainer from the
column.
13.
Disconnect the driver side airbag module wire harness connector from the instrument panel wire harness near the instrument panel lower
reinforcement.
14.
If the vehicle is so equipped, disconnect the overdrive lockout switch wire harness connector from the instrument panel wire harness near the
instrument panel lower reinforcement.
15.
Remove the tilt lever from the steering column.
16.
Remove the lower and upper steering column shrouds.
17.
Disconnect the multifunction switch, speed control switch, and ignition switch wiring harnesses (Figure 6).
