Durango 4WD V8-5.9L VIN Z (1998)
Coupler HVAC: Service Precautions
There are two types of refrigerant fittings:
-
All fittings with O-rings need to be coated with refrigerant oil before installation. Use only O-rings that are the correct size and approved for
use with R-134a refrigerant. Failure to do so may result in a leak.
-
Unified plumbing connections with gaskets cannot be serviced with O-rings. The gaskets are not reusable and new gaskets do not require
lubrication before installing.
Using the proper tools when making a refrigerant plumbing connection is very important. Improper tools or improper use of the tools can damage
the refrigerant fittings. Always use two wrenches when loosening or tightening tube fittings. Use one wrench to hold one side of the connection
stationary, while loosening or tightening the other side of the connection with a second wrench.
The refrigerant must be recovered completely from the system before opening any fitting or connection. Open the fittings with caution, even after
the refrigerant has been recovered. If any pressure is noticed as a fitting is loosened, tighten the fitting and recover the refrigerant from the system
again.
Do not discharge refrigerant into the atmosphere. Use an R-134a refrigerant recovery/recycling device that meets SAE Standard J2210.
The refrigerant system will remain chemically stable as long as pure, moisture-free R-134a refrigerant and refrigerant oil is used. Dirt, moisture, or
air can upset this chemical stability Operational troubles or serious damage can occur if foreign material is present in the refrigerant system.
When it is necessary to open the refrigerant system, have everything needed to service the system ready The refrigerant system should not be left
open to the atmosphere any longer than necessary Cap or plug all lines and fittings as soon as they are opened to prevent the entrance of dirt and
moisture. All lines and components in parts stock should be capped or sealed until they are to be installed.
All tools, including the refrigerant recycling equipment, the manifold gauge set, and test hoses should be kept clean and dry. All tools and
equipment must be designed for R-134a refrigerant.
