Durango 4WD V8-5.9L VIN Z (1998)
Evaporator Core: Service and Repair
Front Evaporator Core
WARNING:
-
REVIEW THE WARNINGS AND CAUTIONS BEFORE PERFORMING THE FOLLOWING OPERATION.
-
ON VEHICLES EQUIPPED WITH AIRBAGS, FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN
ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
REMOVAL
1. Remove the heater-A/C housing from the vehicle, and remove the housing cover. Refer to: Heating and Air Conditioning, Housing Assembly
HVAC, Service and Repair, Heater - A/C Housing Removal and Installation, See: Housing Assembly HVAC/Service and Repair/Heater -
A/C Housing Removal and Installation
Evaporator Coil Remove/Install
2. Lift the front evaporator coil out of the heater- A/C housing.
INSTALLATION
1. Insert the front evaporator coil into the bottom of the heater-A/C housing.
2. Reassemble and reinstall the heater-A/C housing in the vehicle. Refer to: Heating and Air Conditioning, Housing Assembly HVAC, Service
and Repair, Heater - A/C Housing Removal and Installation, See: Housing Assembly HVAC/Service and Repair/Heater - A/C Housing
Removal and Installation
NOTE: If the front evaporator coil is replaced, add 60 milliliters (2 fluid ounces) of refrigerant oil to the refrigerant system. Use only refrigerant
oil of the type recommended for the compressor in the vehicle.