Durango 4WD V8-5.9L VIN Z (1998)
41.
Align the two snap clips on the overhead console housing with their receptacles in the overhead console bracket.
42.
Push upward firmly and evenly on the sides of the overhead console housing over both of the snap clip locations until each of the two snap clips
are fully engaged with the receptacle in the overhead console bracket.
43.
Install and tighten the screw that secures the front of the overhead console housing to the overhead console bracket. Tighten the screw to 1.9 N.m
(17 in. lbs.).
44.
Position the overhead assist handle onto the roof panel and secure the handle with the attaching screws.
45.
Position the coat hook into the roof panel.
46.
Push the coat hook cover inward and secure the coat hook to the roof panel.
47.
Position the sunvisor support into the roof panel.
48.
Push the sunvisor support cover inward and secure the sunvisor support to the roof panel.
49.
Position the sunvisors into the sunvisor supports and align the arm support bracket holes with the headliner holes.
50.
Engage the vanity lamp if equipped.
51.
Install the screws that attach the sunvisor arm support bracket to the headliner and the roof panel.
52.
Position the A-Pillar trim at the A-Pillar, align the spring retaining clips, then press into place.
53.
Install the cowl trim cover.
54.
Perform Steps 44 - 53 to the other side of the vehicle.
55.
On the right side of the vehicle, position the grab handle onto the A-Pillar.
56.
Install the screws attaching the grab handle to the A-Pillar.
57.
Install the trim plugs into the A-Pillar grab handle.
58.
Connect the battery negative cable and reset the clock.
