Durango 4WD V8-5.9L VIN Z (1998)
Housing Assembly HVAC: Service and Repair
Heater-A/C Housing Door Removal and Installation
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN
ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
Blend-Air Door
1. Remove the heater-A/C housing from the vehicle, and remove the housing cover.
Blend-Air Door Remove/Install
2. Lift the blend-air door pivot shaft out of the pivot hole in the bottom of the heater-A/C housing.
3. Reverse the removal procedures to install.
Floor-Defrost Door
1. Remove the heater-A/C housing from the vehicle, and remove the housing cover. Refer to Heater-A/C Housing Replacement for the procedures.
Floor-Defrost Door Remove/Install
2. Remove the push nut retainer that secures the floor-defrost door actuator link to the floor-defrost door crank arm.
3. Disengage the floor-defrost door actuator link from the floor-defrost door crank arm.
4. Remove the floor-defrost door from the heater A/C housing.
5. Reverse the removal procedures to install.
Panel-Defrost Door
1. Remove the heater-A/C housing from the vehicle, and remove the housing cover.