Durango 4WD V8-5.9L VIN Z (1998)
Idle Speed/Throttle Actuator - Electronic: Service and Repair
Fig 75 Mounting Bolts (Screws) - IAC Motor
The IAC motor is located on the back of the throttle body (Fig. 75).
REMOVAL
1. Remove air duct at throttle body.
2. Disconnect electrical connector from IAC motor.
3. Remove two mounting bolts (screws) (Fig. 75).
4. Remove IAC motor from throttle body
INSTALLATION
1. Install IAC motor to throttle body
2. Install and tighten two mounting bolts (screws) to 7 Nm (60 in lb) torque.
3. Install electrical connector.
4. Install air duct at throttle body