Durango 4WD V8-5.9L VIN Z (1998)
Fig 47 Cable Release Tab - Typical
6. Remove cable housing at throttle body mounting bracket by pressing forward on release tab with a small screwdriver (Fig. 47).
-
To prevent cable housing breakage, press on tab only enough to release cable from bracket.
-
Lift cable housing straight up from bracket while pressing on release tab.
-
Remove cable housing.
7. Remove cable from vehicle.
INSTALLATION
1. Snap cable end onto lever pin (Fig. 46).
-
Be sure cable is routed under plastic cam (Fig. 46).
2. Connect cable to throttle body mounting bracket (push down and lock).
3. Install remaining cable housing end into dash panel opening (snaps into position).
Fig 45 Index Tab And Slot
4. Install ball end of cable wire through hole in pedal arm. Install plastic cable retainer. The plastic retainer is snapped into pedal arm. When
installing retainer to accelerator pedal arm, note index tab on pedal arm (Fig. 45). Align index slot on plastic retainer to this index tab.
5. Operate and test throttle before starting engine.
6. Install air tube to throttle body.