Durango 4WD V8-5.9L VIN Z (1998)
5.
No. 5 Cylinder Plug Wire Routing (Figure 10)
A.
Remove the No.5 cylinder plug wire from its distributor cap terminal.
B.
Remove the No.5 cylinder plug wire from the five-wire clip located at the lower rear of the left valve cover.
C.
Route the No.5 cylinder plug wire over the left valve cover and in front of the breather tube elbow.
D.
Position the original convolute from the No.5 cylinder plug wire to prevent chafing against the valve cover and any engine components.
Secure the small end of the hose to wire clip p/n 06503441 over the convolute. Secure the large end of the hose to wire clip to the breather
hose.
NOTE:
MAKE SURE THE NO.5 CYLINDER PLUG WIRE IS SECURE AND AWAY FROM THE NO.7 CYLINDER PLUG WIRE. MAKE CERTAIN
IT WILL NOT FALL DOWN AND CONTACT THE CYLINDER HEAD AND/OR EXHAUST COMPONENTS.
3.9L Engine
