Durango 4WD V8-5.9L VIN Z (1998)
Coolant Temperature Sensor/Switch (For Computer): Service and Repair
Fig. 66 Engine Coolant Temperature Sensor
WARNING: Hot, pressurized coolant can cause injury by scalding. cooling system must be partially drained before removing the coolant
temperature sensor.
REMOVAL
1. Partially drain cooling system.
2. Remove air cleaner assembly
3. Disconnect electrical connector from sensor.
4. Engines with air conditioning:
-
When removing the connector from sensor, do not pull directly on wiring harness.
-
Fabricate an L-shaped hook tool from a coat hanger (approximately eight inches long).
-
Place the hook part of tool under the connector for removal.
-
The connector is snapped onto the sensor.
-
It is not equipped with a lock type tab.
5. Remove sensor from intake manifold.
INSTALLATION
1. Install sensor.
2. Tighten to 11 Nm (8 ft lb) torque.
3. Connect electrical connector to sensor.
-
The sensor connector is symmetrical (not indexed).
-
It can be installed to the sensor in either direction.
4. Install air cleaner assembly
5. Replace any lost engine coolant.
