Durango 4WD V8-5.9L VIN Z (1998)
Switch Mounting Screws
2. Remove 3 ignition switch mounting screws. Use tamper proof torx bit (Snap-On® SDMTR10 or equivalent) to remove screws.
Ignition Switch And Halo Lamp Connectors
3. Gently pull switch away from column. Release connector locks on 7-terminal wiring connector at ignition switch and remove connector.
4. Release connector lock on 4-terminal halo lamp wiring connector and remove connector.
Ignition Switch And Key Cylinder Installation
If installing ignition key lock cylinder only, proceed to following steps 2, 3 and 4. Also refer to following steps 12 through 18. If installing both switch
and key cylinder, refer to steps 1 through 18.
Flag In RUN Position
