Durango 4WD V8-5.9L VIN Z (1998)
7. Remove dust seal from the housing with a seal pick.
CAUTION: Use care not to score the housing bore when prying out seals and washer.
8. Remove retaining ring with snap ring pliers.
9. Remove washer from the housing.
10. Remove oil seal from the housing with a seal pick.
11. Remove pitman shaft bearing from housing with a bearing driver and handle.
ASSEMBLY
1. Install pitman shaft bearing into housing with a bearing driver and handle.
2. Coat the oil seals and washer with grease.
3. Install the oil seal with a driver and handle.
4. Install backup washer.
5. Install the retainer ring with snap ring pliers.
6. Install dust seal with a driver and handle.
7. Install pitman shaft to side cover by screwing shaft in until it fully seats to side cover.
