Durango 4WD V8-5.9L VIN Z (1998)
-
Converter clutch/overdrive solenoid assembly and harness (includes sump temperature thermistor).
-
Governor housing gasket.
-
Solenoid case connector O-rings.
The remaining valve body components are serviced only as part of a complete valve body assembly
REMOVAL
1. Shift transmission into NEUTRAL.
2. Raise vehicle.
3. Remove gearshift and throttle levers from shaft of valve body manual lever.
Transmission Case Connector
4. Disconnect wires at solenoid case connector.
5. Position drain pan under transmission oil pan.
6. Remove transmission oil pan and gasket.
7. Remove fluid filter from valve body.
8. Remove bolts attaching valve body to transmission case.
9. Lower valve body enough to remove accumulator piston and springs.
10. Work manual lever shaft arid electrical connector out of transmission case.
Valve Body
11. Lower valve body, rotate 'valve body away from case, pull park rod out of sprag, and remove valve body.
INSTALLATION
