Durango 4WD V8-5.9L VIN Z (1998)
Lower Housing
29. Turn valve body over so lower housing is facing upward. In this position, the two check balls in upper housing will remain in place and not fall out
when lower housing and separator plate are removed.
30. Remove screws attaching valve body lower housing to upper housing and transfer plate. Note position of boost valve tube brace for assembly
reference.
31. Remove lower housing and overdrive separator plate from transfer plate.
ECE Check Ball
32. Remove the ECE check ball from the transfer plate. The ECE check ball is approximately 4.8 mm (3/16 inch) in diameter.
Transfer Plate
33. Remove transfer plate from upper housing.
34. Turn transfer plate over so upper housing separator plate is facing upward.
