Durango 4WD V8-5.9L VIN Z (1998)
Securing Boost Valve Tube With Brace Tabs
7. Bend tube brace tabs up and against tube to hold it in position.
8. Tighten all valve body housing screws to 4 Nm (35 inch lbs.) torque after tube and brace are installed. Tighten screws in diagonal pattern starting
at center and working outward.
Governor Body, Sensor and Solenoid Assembly
1. Turn valve body assembly over so accumulator side of transfer plate is facing down.
Governor Pressure Sensor
2. Install new 0-rings on governor pressure solenoid and sensor.
3. Lubricate solenoid and sensor 0-rings with clean transmission fluid.
4. Install governor pressure sensor in governor body. Then secure sensor with M-shaped retaining clip.
Governor Pressure Solenoid
5. Install governor pressure solenoid in governor body. Push solenoid in until it snaps into place in body.
