Durango 4WD V8-5.9L VIN Z (1998)
Rear Propeller Shaft
8. Slide the slip yoke off of the transmission, or transfer case, output shaft and remove the propeller shaft.
INSTALLATION
1. Slide the slip yoke onto the transmission, or transfer case, output shaft.
2. Align the installation reference marks made on the propeller shaft and pinion yoke.
3. Align and install the center bearing and heat shield to the support bracket, if necessary.
4. Install the bolts and tighten to 68 Nm (50 ft. lbs.) torque.
5. Position universal joint into the axle yoke.
6. Tighten the universal joint strap bolts to 19 Nm (14 ft. lbs.) torque.
7. Lower the vehicle.
