Durango 4WD V8-5.9L VIN Z (1998)
Bearing Cage And Hub Installed In Housing
4. Insert bearing cage/hub into the housing. Rotate the cage/hub 90° to complete the installation.
5. Apply the lubricant included with the replacement boot to the ball raceways. Spread the lubricant equally between all the raceways. One packet of
lubricant is sufficient to lubricate the complete C/V joint.
Ball Installation In Raceway
6. Tilt the bearing hub and cage and install the balls in the raceways.
Slinger Installation
7. Apply a small amount of lubricant to inner diameter of slinger. Place slinger squarely on the outer C/V joint. Use installer tool L-4518-1 from tool
set L-4518 and hammer slinger onto joint until it seats.
