Durango 4WD V8-5.9L VIN Z (1998)
CAUTION: Prevent damage to the slinger after installation or a when a replacement outer C/V joint is installed.
8. Position the small-diameter end of the replacement boot on the interconnecting shaft. Retain the boot with, a replacement clamp.
9. Apply the required amount of lubricant to the outer C/V joint and boot.
Outer C/V Joint Installation
10. Align the shaft splines to the outer C/V joint splines. Push the outer C/V joint until the snap ring seats in the groove.
11. Ensure that the snap ring is properly seated in the housing. Pull the outer C/V joint from the interconnecting shaft to test.
12. Place the large-diameter end of the replacement boot over the edge of the C/V joint housing. Ensure that the boot is not twisted.
13. Retain the boot on the housing with a replacement retaining clamps.
