Durango 4WD V8-5.9L VIN Z (1998)
Windshield: Service and Repair
WINDSHIELD
REMOVAL
1. Remove rear view mirror.
2. Remove wiper arms and cowl grille.
3. With doors open, remove the weatherstrip from the side windshield moldings.
4. Remove the screws attaching the side windshield molding to the A-pillars.
Fig. 1
5. Cut urethane bonding from around windshield using a suitable sharp cold knife (Fig. 1).
6. Using a long knife, cut urethane bonding from inside the cab at the base of the windshield.
INSTALLATION
WARNING: ALLOW THE URETHANE AT LEAST 24 HOURS TO CURE BEFORE RETURNING THE VEHICLE TO USE.
CAUTION: Roll down the left and right front door glass and open the rear glass slider (if available) before installing windshield to avoid
pressurizing the passenger compartment if a door is slammed before urethane is cured. Water leaks can result.
Fig. 2