dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Heated Glass Element Switch|Locations|Page 7247 > < Heated Glass Element Switch|Locations|Page 7245
Page 1
background image

Heated Glass Element Switch: Testing and Inspection

For circuit descriptions and diagrams, refer to Rear Window Defogger in Wiring Diagrams.

WARNING:  ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO PASSIVE RESTRAINT SYSTEMS BEFORE ATTEMPTING ANY
STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE PROPER
PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

1. Disconnect and isolate the battery negative cable. Remove the lower bezel from the instrument panel and unplug the rear window switch wire

harness connector.

2. Check for continuity between the ground circuit cavity of the rear window switch wire harness connector and a good ground. There should be

continuity. If OK, go to Step 3. If not OK, repair the open circuit as required.

3. Connect the battery negative cable. Check for battery voltage at the fused B(+) circuit cavity of the rear window switch pod wire harness

connector. If OK, go to Step 4. If not OK, repair the circuit to the Power Distribution Center (PDC) fuse as required.

4. Turn the ignition switch to the ON position. Check for battery voltage at the fused ignition switch output (RUN) circuit cavity of the rear window

switch wire harness connector. If OK, go to Step 5. If not OK, repair the circuit to the junction block fuse as required.

5. Turn the ignition switch to the OFF position. Disconnect and isolate the battery negative cable. Plug the wire harness connector into the rear

window switch. Connect the battery negative cable. Turn the ignition switch to the ON position. Back probe the rear window defogger relay output
circuit cavity of the rear window switch pod wire harness connector. Depress and release the rear window defogger switch. There should be
battery voltage. Depress and release the rear window defogger switch again. There should be zero volts. If OK, go to Step 6. If not OK, replace
the faulty rear window switch pod.

6. Depress and release the rear window defogger switch. The rear window defogger indictor LED should light. If the indicator LED does not light,

replace the faulty heater-A/C control assembly.

Heated Glass Element Switch|Locations|Page 7247 > < Heated Glass Element Switch|Locations|Page 7245