dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

A/C Heater Control Calibration - Front|Page 7344 > < A/C Heater Control Calibration - Front|Page 7342
Page 1
background image

Control Assembly: Service and Repair
Rear

REMOVAL

OVERHEAD RAIL MOUNTED

1. Disconnect and isolate the negative battery cable.

Rear A/C - Heater Control - MTC System Shown

2. Using a trim stick C-4755 or equivalent, gently pry the rear A/C-heater control housing off of the overhead rails.
3. Remove the rear A/C-heater control and housing assembly from the overhead rails and disconnect the wire harness connector(s) from the back of

the control.

Rear A/C - Heater Control Housing - MTC System Shown

4. If required, remove the three screws that secure the rear A/C-heater control to the housing and remove the control from the housing.

A/C Heater Control Calibration - Front|Page 7344 > < A/C Heater Control Calibration - Front|Page 7342