Grand Caravan V6-3.3L VIN R (2005)
4. If headliner mounted, insert the locator tabs on the back of the rear A/C-heater control bezel over the forward edge of the opening in the headliner
and using hand pressure, push the rear A/C-heater control bezel into the headliner until the two retaining clips fully seat.
5. If overhead rail mounted, position the top of the rear A/C-heater control housing over the overhead rails and using hand pressure, push the rear
A/C-heater control housing onto the overhead rails until the retaining clips fully seat.
6. Reconnect the negative battery cable.
7. Using the DRB-III(R) scan tool, reset the Rear Temperature Selector calibration values.
8. Verify that the Actuator Calibration of the Front Control has passed. If an Actuator Calibration has not passed correct any errors before proceeding
further.
9. Rotate the Rear Temperature Selector counter clockwise to the Cold Position, allow the Selector to remain in the Cold Position for 5 seconds.
10. Rotate the Rear Temperature Selector Clockwise to the Hot Position, allow the Selector to remain in the Cold Position for 5 seconds.
11. Calibration is now complete.